Step 1 - Clean It
Remember to Prep the Surface
- Pour 1-part denatured alcohol (or rubbing alcohol) and 1-part water into a spray bottle or bowl. Wipe surface down with mixture.
- Rinse off any residue with warm water.
- Lightly scuff up any glossy or smooth surfaces to give them tooth.
- 1-part rubbing alcohol and 1-part water.
- Krud Kutter® (Found in most hardware stores)
Other Cleaners That Work
Step 2 - Tape It
Tape Off Any Windows or Hardware you can't remove.
Make sure your lines are clean and straight.
Step 3 - Prime It
Apply 2 coats of Wood'n Primer
2 coats are all you need. Make final strokes long in the direction you want the grain.
- Clean your brush after each coat.
- Allow 2 hours for each coat to dry completely.
- If you are limited on time, then use a blow dryer (Dry time may take as little as 5 minutes when using a blow dryer on high heat)
Step 4 - Grain It
If you want a smooth finish you can skip this step. Your brush strokes will make a subtle grain.
Grain a thin coat of
Consider if it made of wood planks, where the verticle planks and horizonal planks natually go then grain in that direction for each. This will create the look of planks.
- Apply a thin coat of Wood'n Stain in plank sized sections.
- Pull the graining tool through each section while coat is still wet.
- To achieve a wood knot, move your thumb downward and back up quickly while pulling the graining tool in a smooth continuous stroke (From one end to the other without stopping).
- For best results, don't rock the graining tool back and forth too often or else your surface will appear unnatural.
- If you don't like the grain then apply another coat of Wood'n Stain over that section and grain it again.
Step 5 - Stain It
Just paint it on!
Apply 2 coats for the most popular finish
Make sure brush strokes are long and even (going in the direction of the grain).
Choose Your Finish
Enjoy Your New Wood Front Door
Topcoat is Optional
If you want extra protection you can seal it
- Wood'n Stain already has a topcoat in it, which is durable enough to protect even a deck for over a year.
- If you want more protection, apply thin layers of Tripletique.
- For best results we recommend only using Retique It® brand topcoats.
Net Orders Checkout